I am doing the B.Tech from the Gujarat Technological University (GTU) and in first sem, I have the Engineering-Graphics (EG) as the practical subject. I am facing some problem in this. Can you please share the PPT of the GTU EG practical subject? so I can learn form there?

Ok, here I am providing you the question paper of Engineering Graphics of BE of Gujarat Technological University.

GTU BE Engineering Graphics question paper

Subject code: 110013

Subject Name: Engineering Graphics

Total Marks: 70

Attempt any five questions.

Make suitable assumption wherever necessary.

Figures to the right indicate full marks.

Q:-1 (a) A link PQ of 80 mm length rotates about its centre in the anticlockwise direction. While the link completes one revolution, the insect walks across the length from one end to the other. Plot the locus of the insect assuming the rotation of the link and the motion of the insect as uniform. 07

(b) A string is unwound from a pentagon of 25 mm side. Draw the locus of end P for unwonding the one turn of string. String is kept tight during the operation of unwounding. Give the name of curve. Draw the tangent and normal to the curve at any point. 07

Q:-2 (a) A line AB 65 mm long appears to be 55 mm in plan and 45 mm in elevation. It’s end A is 20 mm below H.P. and 40 mm behind V.P. Draw projections of a line and find the true angle of inclinations of line with H.P. and V.P. 07

(b) A circular plate of negligible thickness and 46 mm diameter appears as an ellipse in the top view, having its major axis 46 mm long and minor axis 28 mm long. Draw its front view when the major axis of ellipse makes an angle of 60o to V.P. 07

Q:-3 (a) A square prism, having base 30 mm side and axis 50 mm long, has its axis inclined at 45o to the H.P. and has an edge of its base on the H.P. and inclined at 30o to the V.P. Draw the projection. 07

(b) A cone, having diameter of base 50 mm and axis 65 mm long, is lying on the ground on one of its generator with the axis parallel to V.P. It is cut by a horizontal section plane 12 mm above the H.P. Draw its sectional top view and development of surface for the remaining part of cone. 07

Q:-4 (a) A line is measuring 80 mm long has one of its end 60 mm above H.P. and 20 mm in front of V.P. The other end is 15 mm above H.P. and in front of V.P. The front view of the line is 60 mm long. Draw the projection of line and find the 07

GTU BE Engineering Graphics question paper





Contact-

Gujarat Technological University
Near Visat Three Roads, Visat - Gandhinagar Highway, Chandkheda, Ahmedabad, Gujarat 382424