Ok, here I am providing you the syllabus of Heat and Mass Transfer of BE Mechanical Engineering of Indian Institute of Technology Bombay so.

IITB BE Mechanical Engineering Heat and Mass Transfer syllabus

INTRODUCTION – Typical heat transfer situations,
Modes of heat transfer

Introduction to laws, some heat transfer parameters

CONDUCTION – Fourier’s law and thermal conductivity
Differential equation of heat conduction, boundary conditions and initial conditions

Simple one dimensional steady state situations – plane wall, cylinder, sphere (simple and compex situations), concept of thermal resistance, concept of U, critical radius.

Variable thermal conductivity (exercise)

Special one dimensional steady state situations – heat generation, pin fins

Other fin configurations (exercise)

Two dimensional steady state situations

Transient conduction

Lumped capacitance model

One dimensional transient problems – analytical solutions

One dimensional Heisler charts

Product solutions

Numerical methods in conduction

Steady state one dimensional and two dimensional problems

One dimensional transient problems – Explicit and implicit
RADIATION

Basic ideas, spectrum, basic definitions

Laws of radiation, black body radiation, Planck’s law, Stefan Boltzman law, Wien’s Displacement law, Lambert cosine law
Radiation exchange between black surfaces, shape factor
Radiation exchange between gray surfaces – Radiosity-Irradiation method

Parallel plates

Enclosures (non-participating gas)

Gas radiation

FORCED CONVECTION

Concepts of fluid mechanics

Differential equation of heat convection

Laminar flow heat transfer in circular pipe – constant heat flux and constant wall temperature, thermal entrance region,
Turbulent flow heat transfer in circular pipe, pipes of other cross sections

Heat transfer in laminar flow and turbulent flow over a flat plate, Reynolds analogy

Flow across a cylinder and sphere, flow across banks of tubes, impinging jets

NATURAL CONVECTION

Introduction, governing equations,Vertical plate – Pohlhausen solution, horizontal cylinder, horizontal plate, enclosed spaces

HEAT EXCHANGERS

Types of heat exchangers, LMTD approach – parallel, counter-flow, multi-pass and cross flow heat exchanger, NTU approach – parallel, counterflow, shell and tube, cross flow heat exchanger

Condensation and Boiling

Dimensionless parameters, boiling modes, correlations, Forced convection boiling, laminar film condensation on a vertical plate, turbulent film condensation

Mass Transfer

Analogy between heat and mass transfer, mass diffusion, Fick’s law of diffusion, boundary conditions, steady mass diffusion through a wall, transient mass diffusion, mass convection, limitations of heat and mass transfer analogy.

Contact-

Indian Institute of Technology Bombay
Powai
Mumbai, Maharashtra 400076