Will you please get the Network Analysis program syllabus issued by Savitribai Phule Pune University on which paper is based?

Don’t worry I will get the Savitribai Phule Pune University, Network Analysis program syllabus on which paper is based so that you can start prepare for it.

Here is the syllabus

Unit 1
Types of Networks: Lumped and Distributed, Linear and Nonlinear, Bilateral and Unilateral, Time-variant and Time-invariant. Independent and Dependent (controlled) voltage and current sources. Concept of voltage and current divider, Source transformation and shifting. Network Equations: Network equations on Loop basis and Node basis, choice between Loop analysis and Nodal analysis. Concept of super node and super mesh, mutual inductance, Dot convention for coupled circuits, Concept of duality and dual networks.
[7 Hrs]

Unit 2
Superposition, Thevenin, Norton, Maximum Power Transfer Theorem, Reciprocity, Millman theorems applied to electrical networks with all types of sources.
[7 Hrs]

Unit 3
Solutions of differential equations and network equations using classical method for R-L, R-C and R-L-C circuits, Initial and Final Condition (series and parallel).
[8 Hrs]

Unit 4
Basic Properties of Laplace Transform, Laplace Transform of Basic R, L and C components, Solutions of differential equations and network equations using Laplace transform method for RL, R-C and R-L-C circuits (series and parallel), Inverse Laplace transforms, transformed networks with initial conditions. Analysis of electrical circuits with applications of step, pulse, impulse & ramp functions, shifted & singular functions the convolution integral. Laplace transforms various periodic and non periodic waveforms application of Laplace transforms. [9 Hrs]

Unit 5
Two Port Network: Z, Y, H and transmission parameters, Interrelations between parameters. Input power, Power transfer and Insertion loss: Energy and power, Effective or Root-Mean – Square values, Average power and complex power, Problems in Optimizing power transfer, Insertion Loss. Introduction to passive filters, low pass filters, high pass filters and m-derived LPF and HPF filters and design. [8 Hrs]

Unit 6
Network Functions: Poles and Zeros: Terminal pairs or ports, network functions for the one port and two ports, the calculation of network functions, general networks. Poles and zeros of network functions, Restrictions on poles and zeros locations for transfer functions and driving point function, Time –domain behaviour from the pole and zero plot. Stability of active networks. Parallel Resonance, Resonance frequency, Quality factor, Current and resonance.


List of Experiments:
Any four experiments from the first five of the following and any four experiments from rest of the list. (Minimum four experiments should be based on simulation software PSPICE/MATLAB along with hardware verification)
1. Verification of Superposition theorem in A.C. circuits.
2. Verification of Thevenin’s theorem in A.C. circuits.
3. Verification of Reciprocity theorem in A.C. circuits.
4. Verification of Millmans’ theorem.
5. Verification of Maximum Power Transfer theorem in A.C. circuits.
6. Determination of time response of R-C circuit to a step D.C. voltage input. (Charging and discharging of a capacitor through a resistor)
7. Determination of time response of R-L circuit to a step D.C. voltage input. (Rise and decay of current in an inductive circuit)
8. Determination of time response of R-L-C series circuit to a step D.C. voltage input.
9. Determination of parameter of Two Port Network.
10. Determination of Resonance of R-L-C Parallel circuit
11. Determination of Resonance, Bandwidth and Q factor of R-L-C series circuit.

Address:-
Savitribai Phule Pune University
Ganeshkhind, Pune, Maharashtra 411007

Phone:-
020 2569 6064