Yes I will get the Production Engineering exam paper issued by Savitribai Phule Pune University so that you can solve it easily.

Here is the exam paper


Q1) a) Explain with neat sketch oscillating turning process and compare it with conventional turning process. [8]

b) Explain Cryogrinding process. State its advantages. [8]

OR
Q2) a) Explain the chip formation mechanism in High speed machining. State advantages of High speed machining. [8]

b) Explain the development of tool material used in advanced machining process.

Q3) a) State the requirement of tool material used in EDM? Explain the taper and overcut in EDM. [8]

b) Explain with neat sketch STEM process. [8]
OR

Q4) a) For a Rc Ckt adjusted for maximum power supply, following details available, Resistance R = 300 Ohm, Capacitance C = 50 microfarad, Supply voltage = 80 V. Calculate charging current, at the Instant when the CKT is switch on, frequency of discharge. [8]

b) Explain with neat sketches the defects seen in product if it machined by chemical machining.

Q5) a) Compare Hot forging, cold forging, and warm forging. [9]

b) Explain with diagram a precision forging process and write its advantages.[9]
OR

Q6) a) Explain the procedure for preparation of a blank for three roll forming process. [9]

b) Explain with diagram magneto forming process and write its advantages.[9]




Savitribai Phule Pune University, Production Engineering exam paper
unipune.ac.in/university_files/pdf/old_papers/oqp-april-2011/Engineering/b.e..PDF


Address:-
Savitribai Phule Pune University
Ganeshkhind, Pune, Maharashtra 411007

Phone:-
020 2569 6064