#1
June 1st, 2016, 02:47 PM
| |||
| |||
SRMEEE M Tech Question Papers
Hello sir I want to prepare for SRMEEE M Tech exam and here want question paper for practice so can you please give me its details ?
|
#2
June 1st, 2016, 03:42 PM
| |||
| |||
Re: SRMEEE M Tech Question Papers
Hey as per your demand here I am providing you SRMEEE M Tech Question Papers M Tech Question Papers Furniture in a room is treated as a) Dead load b) Imposed load c) Moving load d) Dynamic load In case of pitched roofs up to a slope of 300 the wind load acts a) Away from roof b) Towards the roof c) Away from roof on windward side and towards the roof in leeward side d) Towards the roof on windward side and away from the roof in leeward side Grillage foundation is a) RCC foundation b) Foundation below closely spaced columns c) Steel foundation d) A type of pile foundation The most suitable type of foundation for a 2 storey building on expansive soils is a) Under-reamed pile foundation b) Pre-cast driven piles c) Raft foundation d) Cast-in-situ pile foundation The dimensions of modular clay bricks are a) 220X95X65 mm b) 200X100X100 mm c) 230X115X75 mm d) 190X90X90 mm The most commonly adopted bond in brickwork in India is a) Flemish bond b) Stretcher bond c) Header bond d) English bond Bond stones are a) Provided in brickwork b) Provided at the junction between column and brickwork c) Stones which extend through the thickness of wall in stone masonry d) Interface between stone and brick masonries The best type of masonry among the following is a) Random rubble masonry b) Coursed rubble masonry c) Squared rubble masonry d) Ashler masonry Cavity walls are provided a) To prevent dampness b) To increase strength c) To act as partitions d) To make structures earthquake resistance The fundamental principle of surveying is to a) Work from part to whole b) Work from whole to part c) Work from low level to high level d) Work from high level to low level The reduced bearing of 242045’ a) S62045’ b) W62045’ c) N62045’ d) E62045’ The GTS benchmarks are established by a) Archeological Survey of India b) Ministry of Urban Development c) Ministry of Surface Transport d) Department of Survey of India The observed staff reading on a staff held at a point is 3.65m. The staff was found to be 0.2m off the vertical. The corrected reading on the staff was a) 3.655 b) 3.645 c) 3.564 d) 3.466 The contour interval is a) The horizontal distance between two consecutive contour lines b) The vertical distance between two consecutive contour lines c) Half the horizontal distance between two consecutive contour lines d) Half the vertical distance between two consecutive contour lines Of the following grades one does not belong to standard grade of concrete as per IS 456:2000. Identify it. a) M35 b) M30 c) M25 d) M20 Maximum water cement ratio permitted for structural concrete is a) 0.40 b) 0.45 c) 0.55 d) 0.60 28) In a simply supported RCC ‘T’ beam of span 6m, web width 250 mm, beam centre to centre spacing 4m supporting a slab of 120 mm monolithically cast the effective width is a) 1970 mm b) 2270 mm c) 3000 mm d) 2000 mm The development length in tension Ld for a 20 mm diameter bar with longitudinal stress of 230 N/mm2 and bond stress is 1.2 N/mm2 is a) 958 mm b) 858 mm c) 500 mm d) 300 mm In RCC columns the maximum spacing of longitudinal bars measured along the periphery of the columns is a) 250 mm b) 200 mm c) 350 mm d) 300 mm |
|